Casefeeding

Casefeeder is on but will not rotate.
1. Brass caught under casefeed plate.
2.  Casefeed is too full.
3.  Bad micro-switch.

Cases are falling down tube upside down jamming in the top tube, etc.
1.  Using the wrong casefeed plate for that caliber.
2.  Casefeed baffle (13688) not in place (see conversion chart for which cal. require use of the casefeed baffle)
3. Casefeed is too full.
4. The machine is not secured to a sturdy enough bench.

Casefeed tube (13761 or 14392) appears too short.
1.  Casefeed is not pushed down all the way on the casefeed mounting post (13831).

Cases hanging up at micro-switch or micro-switch inoperative.
1. Check the angle of the switch lever and adjust as necessary.
  a.  Too sharp an angle will cause cases to hang up.
  b. Too shallow an angle will cause incomplete shutoff.

Cases jamming at the casefeed arm (13716).
1. Wrong size or loose body bushing for caliber being loaded.
2.  Operating machine too fast.
3. Not moving the handle a complete cycle.
4. Dented or squashed cases.