Remove the casefeed parts bag from the casefeed bowl and remove the casefeed assembly from the box Figure 12.

1.  Spacer Washer  Figure 13: (see casefeeder schematic) Some calibers call for a spacer washer to be used under the casefeed plate. Installation of this washer raises the plate up a bit to make the feeder function  properly with longer pistol cases (such as .357 Magnum, .44 Magnum and .30 M1)
Note: The spacer washer does not come   factory installed.
  To install the spacer washer, follow these steps:
  a.  Figure 14 Remove the casefeed plate.
  b.  With the casefeed plate removed, disassemble the clutch drive. To do so unscrew the two clutch screws.
  c.  Install the spacer washer as illustrated in the casefeed schematic.
IMPORTANT: The spacer washer goes between the lower clutch and the casefeed plate.
  d. Reassemble the clutch drive and reinstall the casefeed plate.
(Note how the clutch drive engages the drive pin).
Note: The clutch comes factory adjusted (if you don't have to install the spacer washer you shouldn't have to adjust the clutch drive).

Continued...

Continued...