Caliber Conversion Section (continued)
Step 14 Case
insert slide cam - turn around Figure 183. The
case insert slide is reversible. The long side of the cam (see arrow "A" Figure 184) is for pistol and the short side of the cam (see arrow
"B" Figure 184) is for rifle. As a reference, any case as
long or longer than .223 Rem. will require that the short (rifle) side of the cam be
used.Reverse the case insert slide cam only if your caliber conversion requires it.
1. Using a 5/32" Allen wrench, remove the cam screw Figure
185 and reverse the case insert slide.
2. Figure 186 Insure that the back side of the cam is
flush with the cam slide.
3. Replace the cam screw and snug it.
Step 15
Change out the casefeed disc Figure 187. Change the casefeed disc
only if your caliber conversion requires it.
1. Grip the casefeed plate clutch drive Figure 187 and
pull upward. The casefeed disc will slip off the motor drive shaft.
2. To install the new casefeed plate - place the casefeed plate clutch
drive on the motor driveshaft. Slowly rotate the disc until the groove on the drive shaft
aligns with the notch in the plate. The casefeed plate will then slip down onto the motor
shaft and into place.
 |
 |
 |
 |
 |