Rifle Toolhead Set Up (Page
8)
Station 2 -
Installation of the failsafe rod assembly
The purpose of the powder
measure fail-safe rod (Figure 100) is to return the powder bar to its
re-charge position.
1. Using your forefinger, move the lock-link (#17838) down to align the
hole with the slot on the Powder Measure bellcrank (#17839) Figure 101.
2. Insert the rod (#97000) through the holes Figure 102.
3. Loosen the blue plastic wing nut (#13799) Figure 102.
4. Slide the failsafe rod into the failsafe return bracket. Push the
shoulder washer up into place (see arrow Figure 103) and tighten the
blue plastic wing nut until the spring just touches the underside of the bracket.
Note: The powder magazine is filled and the powder bar is adjusted after installing and adjusting the rest of the dies.
 |
 |
 |
 |