Pistol Toolhead Set Up (Page
6)
Station 2 - Installation of the failsafe rod
assembly (Figure 48)
The purpose of the powder
measure fail-safe rod is to return the powder bar to its re-charge position if the powder
bar springs should fail to return it.
1. Using your forefinger, move the lock-link (#17838) down to align
the hole with the slot on the Powder Measure bellcrank (#17839) Figure 49.
2. Insert the rod (#97000) through the holes Figure 50.
3. Loosen the blue plastic wing nut (#13799).
4. Slide the failsafe
rod into the failsafe return bracket. Push the shoulder washer up into place (see arrow Figure 51) and tighten the blue plastic wing nut until the spring just
touches the underside of the bracket.
Note: Do not fill the powder measure or adjust the powder bar until the rest of the dies are installed and adjusted.
 |
 |
 |
 |