6. Place
the casefeeder on its post. Find the clear feed tube and place the bottom of the tube into
the 12 Ga. casefeed sleeve (#17130). Align the casefeeder on the post with the clear feed
tube and snap the feed tube into its receiver. Snug the 1/4-20 screw on the rear of the
casefeeder to secure the position of the casefeeder. Please do not fill the clear feed
tube with empty hulls. This step will be completed later. (Figure 7)
| Click on image to see
larger picture |
 |
| Figure 7 |
Be sure to secure the small, but
important, screw located at the rear of the bowl at the base. This little screw (#13685)
secures the entire bowl assembly to the casefeed post (17123). (Figure
8)
7. The powder measure (#20782) is the next item we'll be installing on
the
| Click on image to see
larger picture |
 |
| Figure 8 |
|
|
machine. Familiarize yourself
with its operation - every complete stroke of the powder bar dispenses one charge of
powder. The dispenser is hull activated. Using a 7/16" wrench, rotate the bolt
located on the end of the powder bar - counterclockwise will reduce the powder charge
weight, clockwise will increase the powder charge weight. (Figure 9)
| Click on image to see
larger picture |
 |
| Figure 9 |
8. Remove the blue cap on the powder die (#16744). Loosen
the two Allen screws and place the powder measure (#20782) on the powder die (#16744). The
clamp must lock into the groove of the die, then secure the two Allen screws firmly. (Figure 10)
| Click on image to see
larger picture |
 |
| Figure 10 |
|
