1. Fasten the
strong mounts (#16065) to the base of the machine while it is lying on its side. (Figure 2)
| Click on image to see
larger picture |
 |
| Figure 2 |
2. Lift the machine up and fasten the machine securely to
the forward edge of the bench. (Figure 3)
| Click on image to see
larger picture |
 |
| Figure 3 |
3. Install the casefeed post (#17123) and the shot post
(#17124) to the frame of
| Click on image to see
larger picture |
 |
| Figure 4 |
|
|
the machine using the two long
4 1/2" bolts, 6 clamps (#13613), 2 - 1/4" washers and 1/4-20 nuts. (Figure 4)
4. Locate the shot container and place it on its post. (Figure 5)
| Click on image to see
larger picture |
 |
| Figure 5 |
5. Open the casefeeder box. Place the feeder on your
bench and plug it into a 110v AC outlet (220v for European casefeeders). Place a handful
of empty hulls into the casefeeder (approximately 10). Turn the unit on and familiarize
yourself with its operation. Notice how every time an empty hull exits the casefeeder, it
passes a microswitch. Later in the loading process, you will see that every time the hull
is next to the microswitch the motor will shut off. (Figure 6)
| Click on image to see
larger picture |
 |
| Figure 6 |
|
