Station Four
- The starter crimp die (#16747) forms and folds the loaded shotshell hull. This die is
set for Winchester AA hulls so we achieve 60% closure of the top. (Figure
24)
| Click on image to see
larger picture |
 |
| Figure 24 |
|
|
Station Five -
Here we'll finish crimp and seat. A final seat plug (#16751) presses the hull back down
and below the top by approximately 1/16 of an inch. The taper crimp feature within the die
radiuses and blends the end of the hull and locks the crimp on the hull. It too is
adjusted for Winchester AA hulls. (Figure 25)
| Click on image to see
larger picture |
 |
| Figure 25 |
|
