4.
Place the hull in station two where the powder measure (#20782) is located. Gently move
the station two locator (#16694) away from the shellplate and insert the hull. (Figure 29)
| Click on image to see
larger picture |
 |
| Figure 29 |
5. Move the roller handle (#22183) down and then back to
its rest position. Remove the hull from the shellplate by pressing down on the locator
button (#16753) and pour the powder back into the clear powder hopper. (Figure 30)
| Click on image to see
larger picture |
 |
| Figure 30 |
6. Repeat steps 4 and 5 a minimum of four times so you
are receiving a uniform powder charge.
7. Weigh the fifth powder charge. Using a 7/16" wrench, rotate the
bolt located on the end of the powder bar. |
|
Counterclockwise will reduce
the powder charge weight. Clockwise will increase the powder charge weight. Adjust as
needed.
8. Again, repeat steps 4 and 5 until you're happy with the powder charge.
Now that you have determined the powder charge, let's go on to station three for
wad and shot insertion. Let's use the same hull, with powder, in station three.
1. Get a supply of wads.
2. Move the roller handle (#22183) to its full aft stop position, away
from you. Doing so will cause the wad swing arm (#16677) to pivot out so you can insert
the wad. (Figure 31)
| Click on image to see
larger picture |
 |
| Figure 31 |
Let the roller handle (#22183) return to its rest position.
3. Remove the clear hopper lid (#17138) and add a small amount of shot to
the shot dispenser. (Figure 32)
| Click on image to see
larger picture |
 |
| Figure 32 |
|
