The Primer System:
The primer feed system on the SL 900 machine is a fully mechanical system. Every complete
stroke of the roller handle (#22183) will feed a new shotshell primer into the machine. (Figure 80)
| Click on image to see
larger picture |
 |
| Figure 80 |
Two very important but simple points:
1. Always keep the machine and its primer feed system clean and free of
dirt. Do not place any oils or grease on the primer feed plate. This hinders the free
flowing operation of the system.
2. Never allow excess powder or dirt to |
|
build up on the deck where the
primer transfer arm (#16691) swings in and out of the machine.
| Click on image to see
larger picture |
 |
| Figure 81 |
If you decide to service your machine
or don't wish to have any primers feeding, install the "stop block" into the
primer system as shown. When you're ready to resume, simply remove the "stop
block" and the primers will begin feeding again the next time you cycle the handle.
|
