4. Return the
roller handle (#22183) to its rest position.
5. Use a 1/4" Allen wrench to unscrew the shellplate bolt (#13418).
6. Remove the shellplate from the machine. (Figure
73)
| Click on image to see
larger picture |
 |
| Figure 73 |
Be careful not to lose the 3/8" index ball (#13891) and index pawl
(#13667) when cleaning and lubing your machine. (Figure 74)
| Click on image to see
larger picture |
 |
| Figure 74 |
When you install your shellplate onto the machine, remember to wipe a light |
|
amount of grease in the
center hole of the shellplate.
7. Reinstall the shellplate.
8. Insert the shellplate bolt (#13418). Thread the shellplate bolt until
it stops, then loosen it no more than one-quarter of a turn. (Figure
75)
| Click on image to see
larger picture |
 |
Figure 75 |
9. Again, move the roller handle (#22183) halfway down
its stroke.
10. Secure the 1/4-28 brass tipped set screw (#13923). Refer to Figure 74
11. Install the ejector wire (#16676). (Figure 76)
| Click on image to see
larger picture |
 |
| Figure 76 |
|
