4. Remove the
powder bar return rod (#17350). (Figure 69)
| Click on image to see larger picture |
 |
| Figure 69 |
5. Remove the two toolhead pins (#14008) located on the
front and rear of the toolhead and frame. (Figure 70)
| Click on image to see larger picture |
 |
| Figure 70 |
6. Slide the toolhead assembly out of the machine and set
it aside.
7. Pick up your other toolhead (#16667) and slide it onto the frame.
8. Insert the two toolhead pins (#14008) into the holes located on the
front and rear of the frame.
9. Install the powder bar return rod (#17350).
10. Install the shot bar return rod (#16733).
11. Attach the shot fitting to the shot dispenser top (#17142).
12. Install the shot fitting e-clip.
You've now completed the toolhead swap - the only step that remains is refilling
the components (powder and shot) and you're ready to go again. |
|
Shellplate Removal
When you service your SL 900 machine - cleaning, lubing, or switching to another
caliber - please follow these steps to remove the shellplate.
1. Remove the ejector wire (#16676). Using a small, flat blade
screwdriver, hook it beneath the ejector wire (#16676) and lift upward to remove it. (Figure 71)
| Click on image to see larger picture |
 |
| Figure 71 |
2. Move the roller handle (#22183) halfway down its
stroke.
3. Use a 1/8" Allen wrench to loosen the 1/4-28 brass tip set screw
(#13923) located on the left side of the machine, below the platform, in the mainshaft
(#13485). (Figure 72)
| Click on image to see larger picture |
 |
| Figure 72 |
|
