Figure
10 The powder measure is held in place by the powder die clamp (#13986).
Tighten in place, but do not over tighten.
 |
| Figure 10 |
Figure 11 & 12 Installation of the Powder Measure Failsafe System.
Insert the rod between the bench and the Square Deal "B" through the hole
in the return bracket (#13355). Release the throttle clip (#13929). Place the clip on the
bellcrank (#20340) and align the holes. Reinsert the rod into place. Install the washer
(#14033) and the wingnut (#13799). With your left hand, move the operating handle (#20114)
to the priming position; press the operating handle firmly forward and with your right
hand adjust the wingnut until the spring is partially compressed. You are now ready to
reload. Refer to the rear view in Figure 11 to assist in the rod
location and proper powder measure positioning.
To install the rod (#13876) remove the blue stripper wingnut (#13799), rod spring
(#14033) and washer (#13738). (Note the order of parts.) See Figure
12 and the schematic on page four. |
|
 |
| Figure 11 |
 |
| Figure 12 |
|
