Place your RL 550B on the edge of sturdy bench or table. Give yourself
about 12 inches of work space on each side of the machine to allow room for components.
Using the machine itself as a template, mark and drill four one-quarter inch holes
in your bench and bolt your RL 550B securely to it (see Figure 1).
| click on image to see larger picture |
|
| Figure 1
Using the machine as a template, mark and drill your 1/4 inch holes allowing 12
inches on each side for your work area. |
Next, mount the cartridge collection bin
bracket (#13803) onto your bench (see Figure
2), allowing approximately one-eighth inch clearance between the platform (#13781) and
the ejected cartridge chute.
Using two screws or bolts, secure the bracket to your bench. The cartridge collection bin
(#13839) simply slides on the bracket (see Figure 3) and will be
inthe proper position to catch ejected loaded rounds. Bolt the operating handle in place
as shown in the schematic. |
|
| click on image to see larger picture |
|
| Figure 2
This photograph shows the correct mounting position of the cartridge collection bin
bracket in relation to the machine. |
| click
on image to see larger picture |
|
| Figure 3 The
cartridge collection bin (#13839) simply slides onto the bracket and will be in proper
position. |
|
