dpp.gif (10671 bytes)

t Table of Contents

Figure 22

figure_22_b.gif (18618 bytes)
Figure 22   Changing powder bars is a snap. Disconnect the springs and, using an allen wrench, loosen the bellcrank screw (#13904) sufficiently to allow you to remove the powder bar. Insert the new powder bar and reverse this procedure.
Back to Adjusting the Powder Charge

contents Top of Page

Table of Contents
Introduction
Don't Suffer in Silence
Mounting the RL550B to Your Bench
Safety Points to Know Before You Begin
To Begin Loading
  Page 1
  Page 2
What Primer Size?
The Toolhead
Choose Your Dies
Carbide Dies?
Setting Your Pistol Dies
  Page 1
  Page 2
Adjusting the Powder Charge
Primer Early Warning System Installation
Primer Magazine
At Last
Troubleshooting
Remember
Notice
Schematics and Parts Lists
Charts

Dillon Precision Products, Inc.
8009 E. Dillon's Way
Scottsdale, AZ 85260 U.S.A.

Call Toll Free 800-762-3845 or 602-948-8009 ° Fax 602-998-2786
Open 7-6 MST, M-F; 8-3 Sat.

E-mail Technical Questions to: tech@dillonprecision.com
E-mail Order Questions to: dillon@dillonprecision.com
E-Mail for Catalog requests to: catalogs@dillonprecision.com

Have technical questions about Dillon Precision's products? Please send them to dillon@dillonprecision.com

Have comments about this web site? Please send them to comments@dillondigital.com
Copyright © 1998 Dillon Digital Innovations, LLC
Last modified: November 29, 1998