Operating circumstances will
dictate the frequency of required lubrication. It is highly recommended that the RL1050 be
cleaned and lubed after every 10,000 rounds of operation.
Use a high grade conventional wheel bearing grease – do not use oil.
Lubrication Points:
- Casefeed Plunger (#13073*)
- Casefeed Plunger Roller (#13498) and Bolt (#13333)
- Swage Connecting Rod (#13417) and Clevis Pin (#13522)
- Tappet (#12995)
- Rocker Arm (#13058)
- Pivot Bolt (#13296)
- Primer Punch Base (#12849 - large or #13307 - small)
|
|
- Alignment Pins (#12972 & #13515 located under the toolhead)
- Shellplate Locating Ring (#12600*)
- Shellplate Lock ring (#20311 - contacting surface)
- Indexing Lever Cam surface (#20312) and Pivot Bolt (#13276)
- Indexing Bolt (#13086)
- Ratchet Restriction Tab (#13376)
- Toolhead Bore (#20420 - lightly to avoid rusting and/or freezing up)
- Connecting Rod (#13324) using grease fittings Cam Guide Bolt (#12486)
- Lever Cam (#13413)
Main Shaft Lubrication - Use only 30 wt. motor oil. DO NOT use
a penetrating lubricant such as WD-40, Breakfree, etc. |
